®
®
Posted on 2022-04-02
We introduced the possibility to print datasheets and calculation reports optionally in US customary units.
Posted on 2022-04-01
We introduced several new features for visualization of magnetic fields.
Posted on 2022-03-31
We introduced optional manual inputs for user defined material parameters for metallic screen, sheath and armour.
Posted on 2021-06-15
Considerations about how to define the load of a system and how this choice influences the simulation results in Cableizer.
Posted on 2021-05-31
On an example from Southwire Company, it is shown how to evaluate a cable pulling project in Cableizer. Special focus is on the useage of imperial units, weight correction factor, vertical bends,...
Posted on 2021-05-24
On an example from Brugg Cables, it is shown how to set up your cable pulling project in Cableizer. This example validates our cable pulling module and has been added to our test cases, ensuring...
Posted on 2021-05-19
With the multi-layer backfill method, it is possible to simulate the filling of a rectangular trench where the cables are buried with two superimposed horizontal layers of different materials,...
Posted on 2021-04-26
Based on an example, the influence of the spacing between crossing systems on the cable rating is discussed and the limitations of the calculation method are outlined.
Posted on 2021-03-29
Results from cable crossing simulations can sometimes be confusing at a first glance. Based on a real example, we investigate the influence of the crossing angle on the cable rating.
Posted on 2021-03-12
We have been doing a general revision of the cable crossing module in Cableizer, with improvements of the preview as well as the reporting. Setting up a cable crossing simulation and evaluating...
Posted on 2021-03-11
Offshore cable protection systems (CPS) need to be carefully modelled in order avoid failure of subsea power cables due to overheating caused by inadequate heat dissipation. We discuss what...
Posted on 2019-08-23
The electrical resistance of cable conductors can now be modelled in the cable editor in three different ways to better illustrate how the value is calculated / provided.